George Robin
04-25-2006, 12:50 PM
I'm in the processof making a couple of interior doors. I've bought shaper cutters and have had no problems creating the stiles and rails (1-3/8" thick). However, I startes shaping the panels with an Oggee shapper cutter and the panles don't look right. I planed the baords to 1" thick, which is what the original doors that I'm replacing were (I cut a cross-section from an old door).
When I adjust the cutter to have a 1/4" "tennon", the inside edge of the oggee profile is not there. The profile basically "rounds off" the interior surface instead of creating a lip.
Suggestions?
TIA George
When I adjust the cutter to have a 1/4" "tennon", the inside edge of the oggee profile is not there. The profile basically "rounds off" the interior surface instead of creating a lip.
Suggestions?
TIA George