Jason Morgan
04-24-2006, 10:19 PM
Just finished the BRT (big router table). Pics are attached. Still needs drawer pulls and a fence, but other than that its good to go. Stuffed with a woodpeckers plunge lift and an Hitachi M12V
Bring on the raised panels!
37141
37142
37143
37144
Top is 44 wide x 30 deep x 36 tall. It rides on two castors and two pegs for easy relocation. Finish is wipe on poly. Dust collection is in back. Drawers on the sides are 11 wide and 22 deep on full extension slides. Bottom drawers are 18 wide by 16 tall. by 24 deep. Should make a good home for additional routers and the PC4212 and all its gear.
Even managed to get some curl in the maple for the edge banding. Still not sure I like the drawer faces on the large drawers, but hey, its only a piece of shop furniture. I may replace them with solid fronts when I get some more scrap stock that size. All the maple was left over from a bunk bed project I did a while back.
Thanks for looking.
Bring on the raised panels!
37141
37142
37143
37144
Top is 44 wide x 30 deep x 36 tall. It rides on two castors and two pegs for easy relocation. Finish is wipe on poly. Dust collection is in back. Drawers on the sides are 11 wide and 22 deep on full extension slides. Bottom drawers are 18 wide by 16 tall. by 24 deep. Should make a good home for additional routers and the PC4212 and all its gear.
Even managed to get some curl in the maple for the edge banding. Still not sure I like the drawer faces on the large drawers, but hey, its only a piece of shop furniture. I may replace them with solid fronts when I get some more scrap stock that size. All the maple was left over from a bunk bed project I did a while back.
Thanks for looking.