View Full Version : Tool handles
Steve Hayes
04-18-2006, 3:50 PM
Would it be safe to glue up some 1 inch ash with poly glue to turn some tool handles??
Lars Thomas
04-18-2006, 3:50 PM
I don't see why not. Good old yellow glue would work for that matter.
Bernie Weishapl
04-18-2006, 8:49 PM
Steve I did a couple with Gorilla glue. Worked great.
Jim Becker
04-18-2006, 9:29 PM
Yes it would work fine, but I'd likely use PVA. I really don't like using poly glues unless they really are needed, such as for a strong out-door joint. Too messy to work with. (Wear gloves...you do NOT want it to get on your fingers unless you enjoy having black digits until it wears off... ;) )
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.