Howard Barlow
08-13-2003, 12:02 AM
I'm trying to replace this tablesaw/jointer. The table for the saw, on this side, is about 8". The jointer, far side, is about 4". Both are live together. Check out the blade guard in the top of the pic. It's suspended from the ceiling, but is not used.
I can't afford a typical big European saw. I need a Unisaw type. The best I can come up with is the Dewalt 746. It is priced at $2500 for the basic model without the sliding table, etc. Yikes!!! I don't think so.
I can't get a response to email from Delta or Jet/Powermatic about availability over there.
Does anyone have any info that may help me? I will be in Russia for a couple of weeks in September. I hope to re-outfit an old workshop in an orphanage.
I can't afford a typical big European saw. I need a Unisaw type. The best I can come up with is the Dewalt 746. It is priced at $2500 for the basic model without the sliding table, etc. Yikes!!! I don't think so.
I can't get a response to email from Delta or Jet/Powermatic about availability over there.
Does anyone have any info that may help me? I will be in Russia for a couple of weeks in September. I hope to re-outfit an old workshop in an orphanage.