Wayne Boian
03-22-2006, 9:31 PM
Just finished rebuilding and painting my old Jet 6" Joiner and started putting it back together. On the infeed table there are two spots where light will shine under a straight edge. I think about 2 to 3 thous low, or about as thick as a piece of paper.
Don't think they will be a problem, but it did make me wonder what the spec should be for being flat or parallel end to end.
Any one know?
Thanks Wayne
Don't think they will be a problem, but it did make me wonder what the spec should be for being flat or parallel end to end.
Any one know?
Thanks Wayne