Mark Mandell
08-03-2003, 9:10 AM
Have a 2 hp Reliant collector located in my garage to collect from my basement shop. I'm putting in new 6" piping and would like to eliminate as many bends as possible.
I am thinking about remounting the blower unit so that the intake faces up and the motor shaft runs vertically. Anyone know of a reason why I should not do this? It will allow me to get a 2' straight run into the blower that would not otherwise be possible and will also eliminate a full 90* bend in the piping.
Appreciate the help.
Mark Mandell
I am thinking about remounting the blower unit so that the intake faces up and the motor shaft runs vertically. Anyone know of a reason why I should not do this? It will allow me to get a 2' straight run into the blower that would not otherwise be possible and will also eliminate a full 90* bend in the piping.
Appreciate the help.
Mark Mandell