Joe Chritz
02-16-2006, 12:43 AM
Looking for some information on shiming the outfeed table of this jointer.
Best as I can tell the outfeed sags about .020, maybe more from cutter head to end. It is flat just sagging.
On side of the way has a gib, the other appears solid. I was thinking that shimming one side was a bad idea and shimming both would skew the table.
Just looking for advice before I loosen up the gibs and stick in some shims.
Thanks in advance
Joe
Best as I can tell the outfeed sags about .020, maybe more from cutter head to end. It is flat just sagging.
On side of the way has a gib, the other appears solid. I was thinking that shimming one side was a bad idea and shimming both would skew the table.
Just looking for advice before I loosen up the gibs and stick in some shims.
Thanks in advance
Joe