Some Triton TRA001 Specs

[Jim McLeod]

Hello all,
Looking for some specs of a Triton TRA001 router to see if it will fit my existing mostly homemade router table. A drilling template would probably be a big ask. But maybe some dimensions of base {with sub base removed} and a ballpark of the screw pattern. Trying to see if the plate on my table can accommodate it. Thanks for any replies. Greatly appreciated

[Bill Dufour]

Looks like there are 3d models for folks to make adapters etc.
try this. No idea if you need special software to see it or buy a subscription etc.
Bill D.
https://www.stlfinder.com/model/template-for-triton-tra001-router-base-plate-HKCSv0AY/3307295/

[Curt Harms]

You could use the existing sub base to make a sub base to suit your purposes. I've done it for Porter Cable routers so no help with Triton. It took 2 forstner bits to use Porter Cable style bushings, 1 Vix style bit, a V router bit and a flush trim router bit. Use the existing sub base and mark the holes in the next sub base using the Vix style bit.