Miles Muri
03-24-2024, 9:43 PM
Hello all,
I picked up an old Craftex CT128 with a broken motor and controller with the hopes setting up a 220v 3-phase motor and VFD like the Grizzly G0733 or Craftex CX802 has. I was hoping that someone who has one of the newer machines might be able to help with some of the specs on the motor. The VFD's are easy to find, but I'm not sure exactly which motor will work.
Here's what I'd like to know:
Shaft diameter :
Shaft length :
Pulley diameter : (wondering if it's different from the old model)
Mounting Flange measurements - length between mounting holes on a side (I assume 4 bolts) :
Flange bolt hole diameters:
Motor dimensions :
Motor speed (nominal) :
Any specs that might be marked on the motor casing.
Photos if you've got them!
Thanks!
I picked up an old Craftex CT128 with a broken motor and controller with the hopes setting up a 220v 3-phase motor and VFD like the Grizzly G0733 or Craftex CX802 has. I was hoping that someone who has one of the newer machines might be able to help with some of the specs on the motor. The VFD's are easy to find, but I'm not sure exactly which motor will work.
Here's what I'd like to know:
Shaft diameter :
Shaft length :
Pulley diameter : (wondering if it's different from the old model)
Mounting Flange measurements - length between mounting holes on a side (I assume 4 bolts) :
Flange bolt hole diameters:
Motor dimensions :
Motor speed (nominal) :
Any specs that might be marked on the motor casing.
Photos if you've got them!
Thanks!