Stephen Leung
02-24-2024, 9:33 PM
Hi
Just wondering if anyone has experienced this problem. I've got the King 12" Jointer/Planer. It's pretty similar to the Jet JJP-12.
In planer mode, when I find that sometimes the workpiece feeds until the second roller (after the cutting head) and then the work piece stops moving. When I push on the workpiece, it starts to move again.. You can see the witness marks of the roller on the wood. The J/P is about 2 years old now.
I've had the covers off and can see that the chain and belt drives are both functioning. I also tightened down on the set screws which add pressure where the roller bearings are held with the springs.
Anyone else experience this?
Thanks,
Steve
Just wondering if anyone has experienced this problem. I've got the King 12" Jointer/Planer. It's pretty similar to the Jet JJP-12.
In planer mode, when I find that sometimes the workpiece feeds until the second roller (after the cutting head) and then the work piece stops moving. When I push on the workpiece, it starts to move again.. You can see the witness marks of the roller on the wood. The J/P is about 2 years old now.
I've had the covers off and can see that the chain and belt drives are both functioning. I also tightened down on the set screws which add pressure where the roller bearings are held with the springs.
Anyone else experience this?
Thanks,
Steve