Jay Knobbe
01-21-2024, 3:14 PM
Is there any way to improve the appearance of this?
I cut the banding from red oak. It's approx .090 thick.
The slab I glued it to is 1.5" thick red oak veneer That I had pressed @ the local Hardwood store.
I used cauls, 6 clamps plus 6 bandy clamps
I thought I'd ask before I trim it flush or maybe I need to cut it off and start over?
The piece is 77" long and it's only these 2 areas that look like this.
The pics are a close up shot. It looks worse in the pics than in real life.
The veneer will be sanded, oil base prestain conditioner and a light brown oil based stain applied followed by Arm-r-Seal
I cut the banding from red oak. It's approx .090 thick.
The slab I glued it to is 1.5" thick red oak veneer That I had pressed @ the local Hardwood store.
I used cauls, 6 clamps plus 6 bandy clamps
I thought I'd ask before I trim it flush or maybe I need to cut it off and start over?
The piece is 77" long and it's only these 2 areas that look like this.
The pics are a close up shot. It looks worse in the pics than in real life.
The veneer will be sanded, oil base prestain conditioner and a light brown oil based stain applied followed by Arm-r-Seal