100 watt JPT Mopa fiber Laser setup and run

[stan kern]

setup and experimenting with the new Fiber laser, lots of learning required but this is a start with engraving some metals
very interesting quite different from the CO2 laser


https://stankern.vids.io/videos/4d90d1bf1318e2c4c4/fiber-laser-first-run

[Steve Utick]

setup and experimenting with the new Fiber laser, lots of learning required but this is a start with engraving some metals
very interesting quite different from the CO2 laser


https://stankern.vids.io/videos/4d90d1bf1318e2c4c4/fiber-laser-first-run

Definitely a lot more knobs and button for a fiber laser than a co2. Not sure if you've found it or not yet, but while you are framing your work in LightBurn, you can do a PGUP and PGDN to increase and decrease the scale of your drawing in addition to being able to move it around the work area as you've found. Good choice on LightBurn though, a lot more user friendly and stable than EZCad.

[stan kern]

thanks will try it, I find there still things I have not used or tried