square and compass

[stan kern]

these are good looking designs , found this one and i will trace it using logic trace and create a *.dxf file to cut it on the CO2 laser


https://stankern.vids.io/videos/0690d1b41c10eac78f/square-and-compass

[Keith Outten]

Very nice Stan, I learn something about the Logic Trace software every time I watch one of your videos.
My current project is tracing a sink cutout for my new solid surface countertops in the kitchen. It's a bit of an odd shape and will be much easier and faster to cut on my CNC Router.

[stan kern]

been there done that
Also I did one with shaper origin way back it ws tricky getting the ID tape behind the counter top but
it did work
After 2024 gets going I am going to get into fiber laser just another spot to learn something new
I ordered a 100w mopa galvo fiber laser , anxious to see how that goes, so my drawing will have to be shrunk down big time
stan

[Keith Outten]

Good luck with the new fiber laser, can't wait to see how it works for you.

[stan kern]

thanks anxious to see what can be done