Noah Mateen
11-26-2023, 9:29 PM
I purchased the 3hp SawStop PCS and then got the 52" Incra TS-LS Fence + Incra Router Table Top. I installed the rails and the router top and got that all level with the SawStop cast iron top. However, when I go to put the base mount onto the rails and slide it towards the saw, it hits the router top. I can lift it and then get it in position, but I wanted to make sure that is expected/correct. Obviously once it's positioned, it will be set in that place (unless I move it to do a wider rip or flip it to use with the router table. Just looking for some guidance/help if I did in fact mess something up.