jack dempsey
11-07-2023, 12:40 PM
Hello,
Does anyone have an idea on this situation with the FS 30. When in jointing mode everything works as it should. However, when trying to use the tool as a thickness planer then the machine will not turn on. I have looked all over for a safety switch or something that keeps the motor from turning on. But to no avail. I purchased this machine used a few years ago. It has worked fine in both modes until yesterday. I have a feeling that it is something obvious staring me in the face, but for the life of me I cannot seem to figure the problem. The manual leaves a lot to be desired. There basically is not trouble shooting section in the manual. I attempted to speak with a tech representative at SCM and was told I would need to register the machine at a cost of $850.00 to speak with a representative. Yes, $850. Thank You.
Does anyone have an idea on this situation with the FS 30. When in jointing mode everything works as it should. However, when trying to use the tool as a thickness planer then the machine will not turn on. I have looked all over for a safety switch or something that keeps the motor from turning on. But to no avail. I purchased this machine used a few years ago. It has worked fine in both modes until yesterday. I have a feeling that it is something obvious staring me in the face, but for the life of me I cannot seem to figure the problem. The manual leaves a lot to be desired. There basically is not trouble shooting section in the manual. I attempted to speak with a tech representative at SCM and was told I would need to register the machine at a cost of $850.00 to speak with a representative. Yes, $850. Thank You.