andrew whicker
10-20-2023, 2:02 PM
Putting these blades on the for the first time (with also new cutter head)
Every measurement I can make keeps telling me that the limiter tip is cutting before the cutter blade. Is the limiter ground incorrectly? Looks like it is sloping up from the sharp edge and I would think it needs to slope the opposite.
It creates a high point that is above the actually cutting knife. Both limiters have the same back cut.
I don't know if it's the head or the knives. Attached are a few end profile photos as well. Looks odd to me. See how the verticals are mis aligned.
509150
509151
509152
Every measurement I can make keeps telling me that the limiter tip is cutting before the cutter blade. Is the limiter ground incorrectly? Looks like it is sloping up from the sharp edge and I would think it needs to slope the opposite.
It creates a high point that is above the actually cutting knife. Both limiters have the same back cut.
I don't know if it's the head or the knives. Attached are a few end profile photos as well. Looks odd to me. See how the verticals are mis aligned.
509150
509151
509152