Whitehill Adj Groover

[andrew whicker]

Hi,

I just got the Whitehill adj groover (4 mm to 15 mm). It didn't come with any specifications / instructions. So I guess I'll cut it with the middle cutter in and see what dimension I get. Looks like it will be around 7mm to 8 mm.

I'm not sure what the approved method is to max out the groove width to 15 mm. Use equal spacers on both sides of the middle cutter I'm assuming is the obvious answer.

[andrew whicker]

Messaged Whitehill over IG.

The middle section is 7.5 mm. Add equal spacers to both sides.

Dumb question maybe, but prefer not to screw up with a shaper.