Freeborn Cutters

[Dan Chouinard]

Opinions please of Freeborn shaper cutters. I found out one of their distributors is in my neighborhood and he will be visiting the shop next tuesday.
Thanks and have a wonderful labor day weekend.

[Paul Haus]

I think I have one in my collection. No problems from what I remember, happens to be one of those I don't use a lot.

[Greg Quenneville]

I bought a beading cutter based on their good reputation and wasn’t disappointed.

[Jim Becker]

While I've never owned any of there products as that kind of tooling isn't needed in my shop, I've only seen good comments about them.

[Mike Cutler]

I have a set for cabinet doors. Well made, work well, but they're pretty expensive. IIRC the set I have was $275.00 used. They were over $400.00 new.
You won't go wrong with the Freeborns, and when you get done with your project, they're easy to resell if you want to recoup some of your $$$. That's how I got mine.
Mine are running on a 3HP Delta shaper.

[Paul Koenigs]

I have a cabinet door set by freeborn, I think I have a few other cutters by them too. (I don't use my shaper very often anymore)
They are a good company, good as any, IMO.

[roger wiegand]

I'm not a big shaper user, but I have a couple of their raised panel sats and a few other cutters and they seem very goof to me.