View Full Version : Cross cutting bevels
tim walker
08-14-2023, 12:57 AM
I need to crosscut a 45 bevel across end grain. What is your recommended blade, crosscut, rip or maybe even a plywood x cut. Cutting 18 mm solid mesquite
John Kananis
08-14-2023, 6:44 AM
If you have a dedicated crosscut blade, this is the way.
Brian Runau
08-14-2023, 7:20 AM
If you have a dedicated crosscut blade, this is the way.
Yes, mando.
Rich Engelhardt
08-14-2023, 7:25 AM
How wide is the piece?
I've used my track saw, miter saw, jointer, router, table saw and miter box & backsaw.
It all comes down to - it depends...
Lee Schierer
08-14-2023, 8:06 AM
Use a good sharp cross cut blade. Take care that the cut off wedge doesn't slide down the blade and jam in the throat plate blade slot.
George Yetka
08-14-2023, 8:37 AM
Yes, mando.
505987 this is how you close.
Rob Luter
08-14-2023, 8:40 AM
Crosscut blade, custom zero clearance insert, backer board.
John Kananis
08-14-2023, 8:59 AM
Haha, too funny. I was wondering if anyone would pick up on the reference.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.