Wyllis Cauvel
08-12-2023, 5:41 PM
First major shot out to Ray and his team. Got me out of some bad config settings, major issue with the Y axis.
Second I'm running as mentioned before a Rabbit Laser 80 1290, RDc6442G controller, latest version of RDWorks V8.01.60
Now the currents issue I'm having is that I can set the Z axis just fine, but for some reason I set origin, but then I hit 'Start" and it lasers some where else on the bed. In addition my laser pointer red dot is not showing up.
I just got this laser from I guy I'm working with, I was running his Universal Laser 660 for a few months until the CO2 tube ran out of gas. So im little familiar with some of this, but the Rabbit is different then before. TY!
Second I'm running as mentioned before a Rabbit Laser 80 1290, RDc6442G controller, latest version of RDWorks V8.01.60
Now the currents issue I'm having is that I can set the Z axis just fine, but for some reason I set origin, but then I hit 'Start" and it lasers some where else on the bed. In addition my laser pointer red dot is not showing up.
I just got this laser from I guy I'm working with, I was running his Universal Laser 660 for a few months until the CO2 tube ran out of gas. So im little familiar with some of this, but the Rabbit is different then before. TY!