tim walker
07-23-2023, 2:02 PM
Hi, I have had an Incra LS Positioner Ultra for many years. Admittedly I don't do a lot of dovetails, but when I do it is almost like going thru the initial learning curve all over. My biggest frustration is the right angle fence and the hold down mechanism or should I say lack of one. Incra recommends using a hand screw clamp to hold stock down while running thru the bit. I have found that to be problematic at times because just a few thousandth off can cause a gap in the dovetail fit.
Has anyone come up with a successful solution for clamping to this fence vs the hand screw? Open to all ideas. Or is there a sled someone has built that serves the same purpose? TIA
Has anyone come up with a successful solution for clamping to this fence vs the hand screw? Open to all ideas. Or is there a sled someone has built that serves the same purpose? TIA