Joe Adams
05-16-2023, 11:20 PM
I have a Trotec Speedy 300 that has a rotary unit which will accept a 80mm or 3" Chuck.
The spindle has a male M10-1.5 stud that is 19mm long to the shoulder.
Trotec sells a Czeck-made TOS Svitavy 80mm 3-jaw chuck with a bolt on adapter for $$$$.
I am looking for a more cost effective solution since I will only use this setup on rare occasions for engraving pens, etc.
Has anyone found an aftermarket chuck and more importantly an M10-1.5 adapter that will work?
Thanks for your help.
Joe
The spindle has a male M10-1.5 stud that is 19mm long to the shoulder.
Trotec sells a Czeck-made TOS Svitavy 80mm 3-jaw chuck with a bolt on adapter for $$$$.
I am looking for a more cost effective solution since I will only use this setup on rare occasions for engraving pens, etc.
Has anyone found an aftermarket chuck and more importantly an M10-1.5 adapter that will work?
Thanks for your help.
Joe