Luis Reyes
04-10-2023, 9:42 PM
Hoping to get some help here! I’m building the Paul sellers tool drawer organizer where I routed some stopped dados in the top and bottom boards where the sides will fit in. I thought I had flat boards but when trying a dry fit of the carcass it wasn’t fitting properly and I discovered the top board has some twist. Any suggestions on how to fix?
It’s a 1/2 inch dado and side boards are 3/4 thick. Depth of dado is 1/4 inch and I had route a 1/4 inch rabbet in the side boards so I effectively fit 1/2 inch into the dado and 1/4 inch rests on the bottom board.
do I remove the twist and then re-route the 1/4 in depth dado?
It’s a 1/2 inch dado and side boards are 3/4 thick. Depth of dado is 1/4 inch and I had route a 1/4 inch rabbet in the side boards so I effectively fit 1/2 inch into the dado and 1/4 inch rests on the bottom board.
do I remove the twist and then re-route the 1/4 in depth dado?