steven c newman
03-28-2023, 4:41 PM
have noticed over the past week or 3....bench vise was having "issues" of the #12 screws holding it to the bench...half were stripped out, and the other half were not far behind...decided to at least stabilize things, rather than tear that end of the bench apart...as I didn't have any 2" thick Oak, anyway....
What I did have, was a bit of 1 x 6 Ash.....was a bit too thick for what I wanted to do..so..
498555
After cross cutting to length, and ripping to width...decided to thin it down a bit...saw blade all the way up...still did not reach the center....but a D8 Rip saw will..
498556
Which left me these 2 slabs.....had to remove the moving part of the vise, then drill and counter sink a few holes...
498557
1-5/8" screws, set into "Good wood" and NOT the metal jaw of the vise....then a drop of 3in1 oil on the rods and the screw, re-assemble the vise (spins with a single finger, now)
498558
Making sure the new jaw works...don't want the Wentworth No.1 to wiggle around..
498559
Focused a spotlight onto the teeth...
498560
Jackson 12", 14ppi Backsaw....
498561
Saw has been given a test drive....saw file is back there in the tool tray...
Have to decide on which saw to sharpen next...
What I did have, was a bit of 1 x 6 Ash.....was a bit too thick for what I wanted to do..so..
498555
After cross cutting to length, and ripping to width...decided to thin it down a bit...saw blade all the way up...still did not reach the center....but a D8 Rip saw will..
498556
Which left me these 2 slabs.....had to remove the moving part of the vise, then drill and counter sink a few holes...
498557
1-5/8" screws, set into "Good wood" and NOT the metal jaw of the vise....then a drop of 3in1 oil on the rods and the screw, re-assemble the vise (spins with a single finger, now)
498558
Making sure the new jaw works...don't want the Wentworth No.1 to wiggle around..
498559
Focused a spotlight onto the teeth...
498560
Jackson 12", 14ppi Backsaw....
498561
Saw has been given a test drive....saw file is back there in the tool tray...
Have to decide on which saw to sharpen next...