Martin Salata
03-13-2023, 2:01 PM
Hey there!
I have an Inca 570 J/P and I'm looking for advice on aligning the belt for the feed rollers. It keeps tracking off (downward) and I've tried everything- adjusting the idle pulley, adjusting the way the motor is mounted, etc... even two different sources of brand new belts.
At this point I'm thinking of setting up a separate motor to drive the feed rollers so any thoughts on that would be great as well. I've got the layout from the old Yahoo group
https://docs.machineatlas.com/Inca+570+Feed+Motorization+Conversion.pdf
But I may look to do a little differently if I can't get the belt to work.
Thanks!!
Martin
I have an Inca 570 J/P and I'm looking for advice on aligning the belt for the feed rollers. It keeps tracking off (downward) and I've tried everything- adjusting the idle pulley, adjusting the way the motor is mounted, etc... even two different sources of brand new belts.
At this point I'm thinking of setting up a separate motor to drive the feed rollers so any thoughts on that would be great as well. I've got the layout from the old Yahoo group
https://docs.machineatlas.com/Inca+570+Feed+Motorization+Conversion.pdf
But I may look to do a little differently if I can't get the belt to work.
Thanks!!
Martin