Julie Ramsay
12-19-2022, 6:46 PM
CX-1200 Co2 Laser was working fine and had just cut circle. Went to cut next piece and it would not cut. :confused:
Have cleaned lens and mirrors. ..... Didn't work
Tried a different file.... Didn't work
Turned off machine to reset... Didn't work
Tried engraving file ....That worked
Tried cutting on same file .... Didnt work
Tried more power ... Didn't work
So will engrave but not cut..... :confused:
Would appreciate any suggestions...
Have cleaned lens and mirrors. ..... Didn't work
Tried a different file.... Didn't work
Turned off machine to reset... Didn't work
Tried engraving file ....That worked
Tried cutting on same file .... Didnt work
Tried more power ... Didn't work
So will engrave but not cut..... :confused:
Would appreciate any suggestions...