View Full Version : Bandsaw Box: Sanding interior
Marc Rochkind
12-06-2022, 4:07 PM
When I cut out the drawer from the shell, the outside of the drawer and the inside of the shell are rough. I can sand them smooth, but then the drawer no longer fits very well.
Options I can think of:
* Leave it rough -- it's the inside!
* Apply flocking, which I see in a few YouTube videos.
What am I missing?
Andrew Hughes
12-06-2022, 4:40 PM
Look up Art Espenet Carpenter he’s the inventor of the bandsaw box. I don’t think it’s a problem with a loose drawer. Maybe with a little research you will your answer.
Good Luck
Myk Rian
12-06-2022, 7:48 PM
Sand the pieces smooth, and cover one/both surfaces with veneer.
The only other way I know of is to use a scroll saw sized blade, and be very accurate in your cut.
Tom Blank
12-07-2022, 1:04 AM
I have glued an slightly oversized 1/8" to 3/16" thick face on the drawer front. The face is usually close to flush on the bottom edge of the drawer and I then used spokeshaves and sandpaper to fit the face to the opening. I trim the depth of the drawer body to leave the face just a little proud of the case. Lots of test fit and sand, test fit and sand. This one is for a granddaughter, she is worthy of the time spent.
491196 491197
jared herbert
12-08-2022, 10:24 AM
I have made a lot of those boxes. I cut some 1/4 inch wide strips of scrap leather, the same color that I use to line the drawers with. I glue them on the bottom of the drawers to make a pair of drawer runners. Keeps the wood pieces from rubbing on each other and it spaces the drawer up just the right amount
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.