Centrifugal switch

[Ricky Kidwell]

I need a centrifugal switch for a grizzly 9965 wide belt sander 10 hp single phase

[Jim Becker]

Grizzly is normally pretty good about parts availability...did you contact them?

[Bill Dufour]

They make solid state starting switches that replace the moving switch. No idea if they can handle that much horsepower.

[Eric Arnsdorff]

As others have mentioned - Grizzly is amazingly good with spare parts for their machines. I've owned several decent machines from Grizzly, but I've went with better quality machines since that point. However, one thing about them is the support for their machines is truly unmatched!

But ... centrifugal switches are fairly universal. There's a good chance you can find a replacement even if Grizzly doesn't carry it.

[Ronald Blue]

One of two centrifugal switches shows still being available.

https://www.grizzly.com/products/g9965/parts

No idea if this is anything close but might be an option.

https://www.amazon.com/Centrifugal-Switch%EF%BC%8CL19-302Y-Mechanical-Controller%EF%BC%8C-Accessory/dp/B07PHTJ5MQ

[Ken Fitzgerald]

At a cost of $105.00 I can see why he's looking for an alternative source!

[Bruce Wrenn]

Correctly sized potential relay could take place of centrifugal switch.

[Bill Dufour]

Not an endorsement but a good reference of what is available. 23 dollars is not bad.
Bill D.
http://catalog.torq.com/category/sinpac--solid-state-switches

https://www.amazon.com/Electronic-Centrifugal-Intelligent-Single-phase-RECS-220P/dp/B082XVFQBS