Andy Hoyt
01-24-2006, 2:56 PM
UPS just delivered my new un-handled scraper. So far so good.
But this one has a square tang on it that is tapered along its length.
So my question is --- What size hole do I bore for it in the end of the handle I'm about to turn?
My thought is shoot for the diameter at the mid point along the length of the tang.
Go a bit deeper than the length and dump some epoxy in to it.
Yes? No? Other?
thanks
But this one has a square tang on it that is tapered along its length.
So my question is --- What size hole do I bore for it in the end of the handle I'm about to turn?
My thought is shoot for the diameter at the mid point along the length of the tang.
Go a bit deeper than the length and dump some epoxy in to it.
Yes? No? Other?
thanks