Dennis Jarchow
09-05-2022, 12:01 AM
I was using my 6-month old Sawstop PCS today and raised the blade all the way up and started setting the blade angle for a bevel cut. I heard a sound like something small dropping to the inside bottom the saw. I assumed it was a piece of wood. When I tried to adjust the bevel, the blade would only go back to about 7 degrees. It moves to 45 degrees with no problems. Also, I noticed when I get to the point where I can't adjust the angle any steeper, I can't adjust the height of the blade either. With the blade angle set to anything shallower than 15 degrees, I can raise and lower the blade the full distance. My 90 deg. limit stop is adjusted correctly.
I have vacuumed out the saw and can't see any obvious debris in the any of the worm gears, threaded rods, or the trunnion brackets and slots. Nor were there any saw parts, nuts, bolts etc. that I could see
Any suggestions? Thanks!
I have vacuumed out the saw and can't see any obvious debris in the any of the worm gears, threaded rods, or the trunnion brackets and slots. Nor were there any saw parts, nuts, bolts etc. that I could see
Any suggestions? Thanks!