Quick Dove Tail Saw Rack

[glenn bradley]

I have never been happy with my DT saw storage. I have other saws other places but like to keep these three handy. I finally took a little time yesterday to take care of this.

484578

The lower section is just two sides with a 3/4" dowel glued in. The top is a block with a 1/4" hole drilled end to end.

484579

I then cut slots for the saw blades and CA glued 1/4" x 1/2" rod magnets into the hole at the appropriate locations. I use 1/8" diameter L hooks to add pegboard holders to the back of each section.

[Mike Henderson]

That's a good idea, especially the magnets. I'm going to have to do something like that. Very inventive.

Mike

[Jim Becker]

I really like that idea, Glenn. I'm starting to at least think a little (very little) about how I want to handle my hand-tools (pardon the expression) in the new shop. Historically, I've kept most things in drawers or on shelves in a closed cabinets, other than my dovetail and crosscut saw which have rudimentary wall mounts.

[Scott Winners]

I like the scrapers holder also. Thanks.

[Tom Bender]

It seems the possibility of tremors inhabits your designs. So many wall storage solutions miss this point. Well done!