View Full Version : Finding center of board
Aaron Inami
08-04-2022, 10:28 PM
This is not really a workshop tool, but... this video just came up for me.
https://www.youtube.com/shorts/wNlLY4CN4Nk
so simple and I have had to do this a lot in the past.
Lee Schierer
08-05-2022, 7:28 AM
My grandfather who was a carpenter taught me that trick. It is a lot faster than doing the math.
Wes Grass
08-07-2022, 10:21 AM
I make a quick division in my head, and make a mark from both edges. Cut between them.
But if you're making multiple divisions, like rows of holes, the angled tape, or rule, is king.
Paul Haus
10-06-2022, 5:44 PM
This is not really a workshop tool, but... this video just came up for me.
https://www.youtube.com/shorts/wNlLY4CN4Nk
so simple and I have had to do this a lot in the past.
Just a quick FYI having just seen this. I find that using a framing square is more accurate for me than using a tape measure. Sometime the tab on the end of the tape measure will make the measure short or long where it doesn't happen with a framing square.
Just 2 cents.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.