James Farrow
01-21-2006, 2:54 PM
Decided to get a router instead of the rotary tool attachment, so...
have a question on the bit(s) I need.
I need to router out some rectangular (rounded ends are not a problem)slots (2 1/2" by 1" so that Sawtooth Hanger Hooks will fit inside) on the back of some wood plaques so they will lie flat on the wall when hung up.
What router bits would I need? Was looking for bits that will leave a flat bottom slot but am not sure which kind I am looking for. I don't want round or v-groved bits as then the hooks won't lay flat on the wood.
Suggestions?
Thanks,
James :)
have a question on the bit(s) I need.
I need to router out some rectangular (rounded ends are not a problem)slots (2 1/2" by 1" so that Sawtooth Hanger Hooks will fit inside) on the back of some wood plaques so they will lie flat on the wall when hung up.
What router bits would I need? Was looking for bits that will leave a flat bottom slot but am not sure which kind I am looking for. I don't want round or v-groved bits as then the hooks won't lay flat on the wood.
Suggestions?
Thanks,
James :)