Sunday Afternoon, waiting on glue to dry...

[steven c newman]

And clothes to dry.
480769
And nothing on the bench....time to get the old grinder out, and set up..
480770
Seems I had quite a "Backlog" of Rusty & Krusty" tools to go through...
480771
Ya think?

Results?
480772
1/2 way point. Block plane ready for work...2 chisels cleaned and sharpened...a few drill bits..
480773
Little tack hammer will need a handle...
480774
As will that 3/4" Firmer chisel..
480775
Stay tuned...:D

[steven c newman]

Drill bits...seems the owner just replaced, rather than sharpened..
480776
Largest is a #10...a few #8s, #7s and #6s....mainly Irwins...and a few Jennings..

Brace to turn them with..
480777
Not too sure about a maker...twist bit adapt will be just set aside....
480778
Them jaws have teeth...too...
480779
Barber chuck...but..which one?
480780
Sweep is 10".

That "automatic" screwdriver is by Millers Falls...
480781
Almost the same size as my North Bros. No. 35....and, takes the same bits.

Still have a Disston D-8 to clean up....at 12 ppi, it will head to Piqua, OH. along with a 10ppi D-8....teeth are too small for me to see, let alone sharpen...


Clothes are dry, and hauled back upstairs....close the shop.

[steven c newman]

A little research. on that Brace drill.....Millers Falls "Mohawk" No. 262....seems to fit...