Ian Scofield
05-05-2022, 9:43 PM
I have a few cabinets that I need to redo some doors on and this is my first foray into cabinet doors, specifically rail and stile. I've got a set matched for those and am good to go there. But now I'm trying to tackle the outer edge profile and it's very basic, but I am unsure as to how these are accomplished as I can't seem to find a bit that does what I'm looking for. Are these potentially done with two bits taking two passes and I need to find the right combination or are they typically a single bit?
This is almost it: https://www.rockler.com/freud-finger-pull-door-lip-bit, but the curved part at the top for these doors is much higher.
It's hard to tell from the pics here: https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html but it seems like Profile A (6312) at the top seems similar for the bottom half as it's straight, but the top seems wrong, but 7854 seems right for the top part as it's curved, but the bottom part is curved and needs to be straight.
Any help would be most appreciated!
478802
This is almost it: https://www.rockler.com/freud-finger-pull-door-lip-bit, but the curved part at the top for these doors is much higher.
It's hard to tell from the pics here: https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html but it seems like Profile A (6312) at the top seems similar for the bottom half as it's straight, but the top seems wrong, but 7854 seems right for the top part as it's curved, but the bottom part is curved and needs to be straight.
Any help would be most appreciated!
478802