tod evans
01-20-2006, 9:45 AM
several folks have expressed an interest in the process so here goes;
30040
first layout your finished radius then come in an inch for fudge factor,using your pivot point bisect your arch at the desired segment length.....
30041
connect the dots using any handy straight board and set a bevel gauge to the prescribed angle..
30042
using the bevel gauge set the miter saw and cut your segments..
30043
check the segments against your pattern....... end part 1
30040
first layout your finished radius then come in an inch for fudge factor,using your pivot point bisect your arch at the desired segment length.....
30041
connect the dots using any handy straight board and set a bevel gauge to the prescribed angle..
30042
using the bevel gauge set the miter saw and cut your segments..
30043
check the segments against your pattern....... end part 1