Robert Marshall
03-04-2022, 8:49 PM
I purchased a set of used tools from a woodturner's widow, a couple of years ago. Recently, I've started looking at a Rolly Munro tool that was part of that set. I need to know more about the cutter element itself; where to purchase replacements, and how to sharpen it.
Here are two photos, from above and below the tool, which should show what it is I have. I'm pretty sure this is not the current version of this tool, but if there are current suppliers who can help me keep this working, I would like to know who they are.
475207
View of tool from above; you can see the cutting edge of the cutter, at far left
475208
View of tool from below
The cutter is held in place by a screw from above.
Can anyone point me to a source for the cutter, and also to sharpening instructions.
Thanks!
Here are two photos, from above and below the tool, which should show what it is I have. I'm pretty sure this is not the current version of this tool, but if there are current suppliers who can help me keep this working, I would like to know who they are.
475207
View of tool from above; you can see the cutting edge of the cutter, at far left
475208
View of tool from below
The cutter is held in place by a screw from above.
Can anyone point me to a source for the cutter, and also to sharpening instructions.
Thanks!