Derek Cohen
02-14-2022, 10:39 AM
This is the last of the four tool boxes I plan to make. Black Walnut and Hard Maple.
https://i.postimg.cc/RCp3Hg1x/9.jpg
Just mitred corners. The notable feature is is that there is no spline or reinforcing. Instead, the end grain corners are sized and glued.
Sizing involved a layer of glue on the end grain, allow to near-dry, then add fresh glue. The glue fills the straws and the joint avoids being glue-starved.
https://i.postimg.cc/2yyVtWDt/10.jpg
The opening to the top in at the end facing the camera ...
https://i.postimg.cc/vHpcPDSP/11.jpg
Here is the finger pull ...
https://i.postimg.cc/5yr6Wt92/12.jpg
Knew Concepts 5" Titanium fretsaw with one of my custom handles, and a kerfing chisel.
https://i.postimg.cc/BQ8jc2NL/13.jpg
Regards from Perth
Derek
https://i.postimg.cc/RCp3Hg1x/9.jpg
Just mitred corners. The notable feature is is that there is no spline or reinforcing. Instead, the end grain corners are sized and glued.
Sizing involved a layer of glue on the end grain, allow to near-dry, then add fresh glue. The glue fills the straws and the joint avoids being glue-starved.
https://i.postimg.cc/2yyVtWDt/10.jpg
The opening to the top in at the end facing the camera ...
https://i.postimg.cc/vHpcPDSP/11.jpg
Here is the finger pull ...
https://i.postimg.cc/5yr6Wt92/12.jpg
Knew Concepts 5" Titanium fretsaw with one of my custom handles, and a kerfing chisel.
https://i.postimg.cc/BQ8jc2NL/13.jpg
Regards from Perth
Derek