David B. Morris
01-12-2022, 4:55 PM
Hello all, I bought a Sawstop PCS a few months ago but am only getting into setting it up now. Aligning the table to the blade is simple enough, but in checking the alignment of the tilt axis (i.e., parallelism between that axis and the table) I found it off by over .003. I followed (or thought I followed) the manual's rather complicated instructions for adjusting it and ended up making it worse. Sawstop says it's the only manufacturer that allows this adjustment on its saws, and I'd like to know how to do it for future reference. Their site has no videos or PDFs on this topic, and their tech service seems unable to give me any additional info.
If any of you have been through this procedure with a Sawstop I sure would appreciate your advice.
If any of you have been through this procedure with a Sawstop I sure would appreciate your advice.