Carl Beckett
01-12-2022, 2:58 PM
Got the overhead guard setup in the new workspace. A few years ago in the old shop I mounted this overhead on a cantilever (just a plywood box construct). This time I went across the ceiling, and under the garage door.
It runs 4" duct to a 6" main. Choked down at the guard to 2.5". The guard itself I bought as replacement parts from the Grizzly overarm, but I was never too keen on the floor standing units so went overhead instead.
Still some adjusting to do, but hoping it works as well as previous. It is good to have the guard back on, and some added dust collection (the messiest machine for me is still the TS - in part because it is the most often used machine.
471539471540471541
(not my motorcycle in the background, just taking up shop space for a friend. But IS my mess in the background...due for a cleanup. I have a problem with horizontal surfaces...)
It runs 4" duct to a 6" main. Choked down at the guard to 2.5". The guard itself I bought as replacement parts from the Grizzly overarm, but I was never too keen on the floor standing units so went overhead instead.
Still some adjusting to do, but hoping it works as well as previous. It is good to have the guard back on, and some added dust collection (the messiest machine for me is still the TS - in part because it is the most often used machine.
471539471540471541
(not my motorcycle in the background, just taking up shop space for a friend. But IS my mess in the background...due for a cleanup. I have a problem with horizontal surfaces...)