PAUL A DALEN
12-02-2021, 8:26 AM
Good morning. I'm planning to put my extension table on the CNC and carve out the opening for a Rockler router lift. But...it's too thin to support the weight of the lift over time. So I need to glue a 3/4 plywood backer onto the bottom.
What is the surface of the table? Is it melamine? Would a melamine glue bond the porous plywood to the surface?
Also, has anyone else done this? If you have Vcarve files you'd share I'd appreciate it.
What is the surface of the table? Is it melamine? Would a melamine glue bond the porous plywood to the surface?
Also, has anyone else done this? If you have Vcarve files you'd share I'd appreciate it.