Mark Gibney
11-19-2021, 2:40 PM
I’m using a brand new Freud cope and stick set, and I get a gap at the cove (Freud 99-760).
I’ve tried multiple ways to adjust the settings on the cope bit but the gap is consistent.
Is there something I can do?
All the door rails are cut to final length so I can’t change that. Thanks for any advice on this.
I used the Freud because it has the adjustability for the plywood panel.
Tempted to try a non-adjustable set, but if there’s a fix of course I’ll try that first.
468402 468401
I’ve tried multiple ways to adjust the settings on the cope bit but the gap is consistent.
Is there something I can do?
All the door rails are cut to final length so I can’t change that. Thanks for any advice on this.
I used the Freud because it has the adjustability for the plywood panel.
Tempted to try a non-adjustable set, but if there’s a fix of course I’ll try that first.
468402 468401