Patrick Irish
09-27-2021, 5:08 PM
I picked up a Laguna lt24 the March Covid started and then had a baby and decided to move. I just now with help from a friend started to process in dialing it in.
Many questions:
Does the fence or blade need to be square to miter slot?
When adjusting, the blade and fence are what dictates consistent cuts especially resaws?
I had to take the table off to move and put it back on. Its 4 simple posts and not much play. I don;t think there's any fine tuning with the table.
Buddy and I finally got some decent resaws done. The wood was being pulled away from the fence and also burning only one side of the maple we were cutting.
I think the 1-1/8" resaw king blade is dull. It was used and I think they hogged a lot of wood with it.
Any tips to fine tune a laguna or bandsaw in general would be helpful.
From my reading, every time the blade is changed, I'll have to re-align the fence to the blade?
Many questions:
Does the fence or blade need to be square to miter slot?
When adjusting, the blade and fence are what dictates consistent cuts especially resaws?
I had to take the table off to move and put it back on. Its 4 simple posts and not much play. I don;t think there's any fine tuning with the table.
Buddy and I finally got some decent resaws done. The wood was being pulled away from the fence and also burning only one side of the maple we were cutting.
I think the 1-1/8" resaw king blade is dull. It was used and I think they hogged a lot of wood with it.
Any tips to fine tune a laguna or bandsaw in general would be helpful.
From my reading, every time the blade is changed, I'll have to re-align the fence to the blade?