Sawmill Creek Woodworking Community
>
Woodworking by Hand and Specialties
>
Turner's Forum
> Taperd stave question
PDA
View Full Version :
Taperd stave question
Tim Elett
08-27-2021, 6:38 PM
Is there any easy way to cut top and bottom of a taperd stave bowl ,which would be a 90 degree angle? Did I read I need to cut half the degrees of the slope.
Tim Elett
08-28-2021, 12:32 PM
I think I got it had to sleep on it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.