dennis kranz
01-12-2006, 1:44 PM
I wanted to show you guys the project that I have been working on. Now I have cut a few of these but this one is a little differant. I was chosen by the family to make this for there daughter who passed very shortly after birth. They had seen one of my cuttings and asked if the initials could be added. I kind of fussed over this piece more so then if it was just another and still a couple of boo boos. All in all it came out ok.
Cut from 1/2 inch Red Oak with the initials being 1/4 inch Walnut. The piece is about 9 1/2 long by 7 inchs tall. I won't post anymore flat work on this turning forum. I have read so many of your posts that I wanted to post something other than a question.
http://img.photobucket.com/albums/v159/cointroller/wood%202/prayinghandsint.jpg
Cut from 1/2 inch Red Oak with the initials being 1/4 inch Walnut. The piece is about 9 1/2 long by 7 inchs tall. I won't post anymore flat work on this turning forum. I have read so many of your posts that I wanted to post something other than a question.
http://img.photobucket.com/albums/v159/cointroller/wood%202/prayinghandsint.jpg