Kreg Accu-cut saw guide

[Carl Crout]

Anybody tried this yet? Pros? cons?

https://www.kregtool.com/shop/cutting/circular-saw-cutting/accu-cut/KMA2700.html?_ga=2.18551481.1459941922.1628087631-198063372.1628087631

[Mike Kees]

Carl I have not tried one of these, but it looks like a cheaper alternative to a tracksaw. If most of your cuts are 50'' or less I think it would work .

[Frederick Skelly]

Heres a previous thread. It's short but might help a little. LINK (https://sawmillcreek.org/showthread.php?259587-Kreg-accu-cut)

[Charlie Jones]

Carl I have not tried one of these, but it looks like a cheaper alternative to a tracksaw. If most of your cuts are 50'' or less I think it would work .

I have one. I have only used it a couple of times. There is some slop in the track but it still seemed to cut a straight line. The vertical cut was canted a little. I checked my saw and it was at 90 degrees. I haven’t tracked down the reason yet. Overall it works good enough. I don’t need a track saw that often.

[Carl Crout]

I have one. I have only used it a couple of times. There is be some slop in the track but it still seemed to cut a straight line. The vertical cut was canted a little. I checked my saw and it was at 90 degrees. I have tracked down the reason yet. Overall it works good enough. I don’t need a track saw that often.

Thanks, I might give it a try

[Dan Rude]

I have used their Rip Guide, it really needed a way to make a zero clearance for the saw blade. It worked well. You might look at the system from BORA it seems to be similar price range. I myself sold the rip guide and went with the TrueTrac system. Dan

[Carl Crout]

I have used their Rip Guide, it really needed a way to make a zero clearance for the saw blade. It worked well. You might look at the system from BORA it seems to be similar price range. I myself sold the rip guide and went with the TrueTrac system. Dan

Thanks very much