steven c newman
03-24-2021, 10:28 AM
Cut down to a manageable length...edges jointed...
454978
Glued up into a panel...
454979
Trim the edges square....(while trying to flatten the panel, panel flip off onto the floor, now had two to work on)
454980
Reglue the two into one panel...
454981
Sand, plane, cut the corners to a radius...
454982
Apply a coat of Mineral Oil....
454983
Waiting to see how it dries....may get a few more coats
5/8" x 10-1/4" x 11".......simple, little cutting board. Strips are from all those "rip an edge of a plank down to size, that I didn't want to throw away" piles.....Ash, Oak, Maple, Pine, Poplar.....a "board of many colours":D
454978
Glued up into a panel...
454979
Trim the edges square....(while trying to flatten the panel, panel flip off onto the floor, now had two to work on)
454980
Reglue the two into one panel...
454981
Sand, plane, cut the corners to a radius...
454982
Apply a coat of Mineral Oil....
454983
Waiting to see how it dries....may get a few more coats
5/8" x 10-1/4" x 11".......simple, little cutting board. Strips are from all those "rip an edge of a plank down to size, that I didn't want to throw away" piles.....Ash, Oak, Maple, Pine, Poplar.....a "board of many colours":D