Bruce Wrenn
03-18-2021, 9:04 PM
Yesterday checked and tuned up my Dubbly for an on going shop project. Using three cut method, found out it was 0.025 out of square over 24". Dividing 0.025 in half yields 0.0125. Had to choose between either 0.012, or 0.013 feeler gauge. Set fence and did second test. Out 0.001 over 24". That's good enough for me. Instead of feeler gauges for original measurements, I use a 12" dial caliper, as I had one. Epic Woodworking has a you tube showing how this is done.