Mike Hollis
03-15-2021, 7:15 PM
Purchased the machine last year, finally got dust collection and power installed to it today.
Was face jointing some 6” reclaimed pine, made it through 3 of 8 boards and the machine just stopped. Verified it still had power, feed breaker hadn’t tripped. Waited a few hours thinking the thermal overload had tripped and should’ve reset - still no luck. The green light is lit (in the center of the on/off button).
I will be calling PM customer support in the morning, but was wondering if anyone had any ideas in the meantime?
Was face jointing some 6” reclaimed pine, made it through 3 of 8 boards and the machine just stopped. Verified it still had power, feed breaker hadn’t tripped. Waited a few hours thinking the thermal overload had tripped and should’ve reset - still no luck. The green light is lit (in the center of the on/off button).
I will be calling PM customer support in the morning, but was wondering if anyone had any ideas in the meantime?