Barry Blitz
02-28-2021, 8:20 AM
What is the tolerance for fit? If a shaft is 10mm, is the inner diameter of the guide/bushing the same? If slightly larger bore is needed, then by how much?
And the same question for the hole needed for the outside diameter for which the bushing will fit (which will not be a metal bore, something softer like phenolic or plastic).
I am planning to make some jigs using press fit type P or H drill guide bushings.
And the same question for the hole needed for the outside diameter for which the bushing will fit (which will not be a metal bore, something softer like phenolic or plastic).
I am planning to make some jigs using press fit type P or H drill guide bushings.